FEAP User Forum

FEAP => Input File Issues => Topic started by: JOYE on September 12, 2020, 10:41:23 AM

Title: Input File PCONTR error
Post by: JOYE on September 12, 2020, 10:41:23 AM
Dear Prof,
I am facing a problem when I execute my input file. It is showing an error like this,

*ERROR* PCONTR: Attempt to solve problem before mesh
         input.  Check for error on FEAP or BINAry record.

In this regard could you please me know where i went wrong and how can i solve this issue.

Thanks
Joye
Title: Re: Input File PCONTR error
Post by: Prof. S. Govindjee on September 12, 2020, 12:32:23 PM
There is an error in your input file.  FEAP is not seeing your mesh.
Title: Re: Input File PCONTR error
Post by: JOYE on September 13, 2020, 06:06:20 AM
Thank you for your reply.

At first, it was going perfectly fine. I do not know what is wrong with my input file, because I have not changed anything in it, I just copied and pasted.
Tell me about a possible error that I investigate.

Thanks
Title: Re: Input File PCONTR error
Post by: Prof. R.L. Taylor on September 13, 2020, 08:41:29 AM
What does the output file have in it?
Title: Re: Input File PCONTR error
Post by: Prof. S. Govindjee on September 14, 2020, 11:17:14 PM
You may have copied and pasted a non-visible control character.  If the file is not long you may want to just start from scratch and just re-type it.
Title: Re: Input File PCONTR error
Post by: JOYE on September 26, 2020, 03:53:19 PM
THANK YOU, NOW IT'S WORKING FINE.