FEAP User Forum

FEAP => Parallel FEAP => Topic started by: wklausler on December 20, 2024, 06:00:29 AM

Title: Periodic Boundary Conditions with Elink Command
Post by: wklausler on December 20, 2024, 06:00:29 AM

Dear FEAP community,

I would like to use parFEAP to run homogenization simulations. To this end, I have a working input file for serial FEAP that uses the PERIodic HILL command and the ELINk command. When I attempt to run this same problem with parFEAP, I get PETSc error regarding mismatched boundary conditions and the simulation crashes.

Is my intended use of parFEAP supported?

Best regards,
Wklausler

Title: Re: Periodic Boundary Conditions with Elink Command
Post by: FEAP_Admin on December 22, 2024, 02:55:55 AM

Can you post an input file for the serial version?  Smaller is better.

Title: Re: Periodic Boundary Conditions with Elink Command
Post by: wklausler on December 23, 2024, 12:58:50 AM

Please see the attached files. 'Imain' is the main input file.