FEAP User Forum

FEAP => Wishlist => Topic started by: maxlox on January 28, 2014, 02:28:58 AM

Title: command output for a limited region
Post by: maxlox on January 28, 2014, 02:28:58 AM

Hi All,
I've the old ver. 7.5 of FEAP
is possible to insert a output command to obtain the stress/strain for a limited portion fo mesh like CSURface?
Frequently I need to trasform the nodal stress in macroscopic forces over a "section" (same as FRAME).

Thanks

Max

Title: Re: command output for a limited region
Post by: Prof. R.L. Taylor on January 28, 2014, 05:56:28 PM

If there are very few nodes then perhaps the "list" option may be adequate.  Otherwise, you probably need to write a user function that outputs the results you want to see.  This will be a user "umacr*.f" where * is in the range allowed by your version.