Author Topic: PARTITION + AUTO TIME  (Read 5895 times)

Yaakov

  • Sr. Member
  • ****
  • Posts: 323
PARTITION + AUTO TIME
« on: August 10, 2017, 02:58:52 PM »
Dear all,

I would ask, is it possible that I can use partition command with auto time stepping in FEAP Input File?

Best regards,
Yaakov
Let's boost FEAP's performance!

FEAP_Admin

  • Administrator
  • FEAP Guru
  • *****
  • Posts: 993
Re: PARTITION + AUTO TIME
« Reply #1 on: August 10, 2017, 05:34:01 PM »
It should work.

Prof. R.L. Taylor

  • Administrator
  • FEAP Guru
  • *****
  • Posts: 2647
Re: PARTITION + AUTO TIME
« Reply #2 on: August 11, 2017, 05:26:10 AM »
My guess is it might not be quite right.  If you do partion 1 with current time step and then partion 2 reduces step to converge then them solution is not at same time. So it is important to be careful

Yaakov

  • Sr. Member
  • ****
  • Posts: 323
Re: PARTITION + AUTO TIME
« Reply #3 on: August 11, 2017, 03:43:39 PM »
Dear Prof. Taylor and FEAP Administrator,

I tested a thermomechanical benchmark with partition & auto time command. It seems a little different (compare with fully solution).

I attached the test results  and input file for both cases.

thanks very much for your help again!

Warm regards,
Yaakov
« Last Edit: August 14, 2017, 08:04:51 AM by Yaakov »
Let's boost FEAP's performance!