« previous next »
Pages: [1]

Author Topic: Input File PCONTR error  (Read 5065 times)

JOYE

  • Jr. Member
  • **
  • Posts: 10
Input File PCONTR error
« on: September 12, 2020, 10:41:23 AM »
Dear Prof,
I am facing a problem when I execute my input file. It is showing an error like this,

*ERROR* PCONTR: Attempt to solve problem before mesh
         input.  Check for error on FEAP or BINAry record.

In this regard could you please me know where i went wrong and how can i solve this issue.

Thanks
Joye
Logged

Prof. S. Govindjee

  • Administrator
  • FEAP Guru
  • *****
  • Posts: 1160
Re: Input File PCONTR error
« Reply #1 on: September 12, 2020, 12:32:23 PM »
There is an error in your input file.  FEAP is not seeing your mesh.
Logged

JOYE

  • Jr. Member
  • **
  • Posts: 10
Re: Input File PCONTR error
« Reply #2 on: September 13, 2020, 06:06:20 AM »
Thank you for your reply.

At first, it was going perfectly fine. I do not know what is wrong with my input file, because I have not changed anything in it, I just copied and pasted.
Tell me about a possible error that I investigate.

Thanks
Logged

Prof. R.L. Taylor

  • Administrator
  • FEAP Guru
  • *****
  • Posts: 2647
Re: Input File PCONTR error
« Reply #3 on: September 13, 2020, 08:41:29 AM »
What does the output file have in it?
Logged

Prof. S. Govindjee

  • Administrator
  • FEAP Guru
  • *****
  • Posts: 1160
Re: Input File PCONTR error
« Reply #4 on: September 14, 2020, 11:17:14 PM »
You may have copied and pasted a non-visible control character.  If the file is not long you may want to just start from scratch and just re-type it.
Logged

JOYE

  • Jr. Member
  • **
  • Posts: 10
Re: Input File PCONTR error
« Reply #5 on: September 26, 2020, 03:53:19 PM »
THANK YOU, NOW IT'S WORKING FINE.
Logged
Pages: [1]
« previous next »