command output for a limited region

[maxlox]

Hi All,
I've the old ver. 7.5 of FEAP
is possible to insert a output command to obtain the stress/strain for a limited portion fo mesh like CSURface?
Frequently I need to trasform the nodal stress in macroscopic forces over a "section" (same as FRAME).

Thanks

Max

[Prof. R.L. Taylor]

If there are very few nodes then perhaps the "list" option may be adequate.  Otherwise, you probably need to write a user function that outputs the results you want to see.  This will be a user "umacr*.f" where * is in the range allowed by your version.